Sable V6-183 3.0L DOHC VIN S MFI (1997)
1. Install windshield wiper pivot arm to windshield wiper pivot shaft, making sure the wiper blade tip is aligned with the park position reference mark
on the windshield.
CAUTION: Before reinstalling windshield wiper blade and arm assemblies, turn ignition switch to RUN, turn wiper switch to LO or HI, and then
turn wiper switch OFF to cycle the wipers and allow them to park. Failure to cycle the wipers may result in incorrect wiper arm positioning
causing the wipers to travel past their intended wipe area and possibly damage the vehicle.
2. Make sure the windshield wiper blade is fully seated on the windshield wiper pivot arm before operating the windshield wiper motor to verify the
correction.
3. Install nut retaining windshield wiper pivot arm to pivot shaft and tighten to 30-40 Nm (22-29 Lb-Ft).
4. Install windshield wiper output arm cover to windshield wiper pivot arm.
5. Check windshield wipers for proper operation and positioning. Refer to adjustments. See: Adjustments
