Sable V6-3.0L VIN 2 Flex Fuel (2005)
4. NOTE: Avoid scratching the pinch weld.
Trim the remaining urethane adhesive on the pinch weld. The urethane adhesive must be smooth and free of cuts and contamination after
trimming. Avoid touching the urethane surface after preparation.
5. CAUTION: Be sure to use the same brand and cure-rate products for the adhesive and primer. Do not mix different brands of urethane
and primer.
Apply urethane metal primer to minor scratches or exposed metal on the pinch weld caused during removal. Do not apply primer to the existing
urethane adhesive.
6. If installing the original windshield glass, remove the excess urethane adhesive.
7. Clean the inside of the windshield glass surface with a non-alcohol based glass cleaner.
8. CAUTION:
-
Be sure to use the same brand and cure-rate products for the adhesive and primer. Do not mix different brands of urethane and
primer.
-
Wipe off the urethane glass prep immediately after each application because it flash dries.
If installing a new windshield glass, and if using the 2-part prep and primer, apply urethane glass prep to the area to be urethaned.
9. CAUTION: Be sure to use the same brand and cure-rate products for the adhesive and primer. Do not mix different brands of urethane
and primer.
NOTE: Sika uses the same black primer for the glass and pinch weld area.
If installing a new windshield glass, apply urethane glass primer to the area where urethane will contact glass. Allow 5 to 7 minutes to dry.
10. Cut the urethane adhesive applicator tip to specification.
