Sable AWD V6-3.5L (2008)
6. Remove the front safety belt anchor-to-seat nut.
-
To install, tighten to 35 Nm (26 lb-ft).
7. NOTE: Passenger seat only.
Disconnect the safety belt tension sensor electrical connector.
8. Remove the B-pillar screw cover.
9. Remove the B-pillar screw.
10. Remove the upper B-pillar trim panel.
-
Pull the lower portion of the upper B-pillar trim panel toward the center of the vehicle to release the retaining clips.
-
Lower the upper B-pillar trim panel from the headliner.
-
Separate the safety belt from the upper B-pillar trim panel.
11. To install, reverse the removal procedure.
D-Pillar Trim Panel
D-PILLAR TRIM PANEL
Exploded View