Topaz V6-182 3.0L (1992)
9. Carefully disconnect drive belt track from motor, allowing belt to pass by gear teeth without engagement.
10. Remove screw from A-pillar bracket to A-pillar.
11. Remove two bolts retaining track assembly to B-pillar.
12. Remove two screws retaining track assembly to inner roof rail.
13. Remove screws from overhead track retaining clips.
14. Disengage vertical guide release tab at B-pillar bracket.
15. Rotate track inboard to remove track limit switch retaining tab from slot in A-pillar.
16. Slide drive belt out of vertical guide.
Installation
1. Insert drive belt in vertical guide.
2. Insert retaining tab on limit switch bracket into slot in A-pillar.
3. Engage vertical guide retaining tab into B-pillar bracket.
4. Install two retaining bolts at B-pillar. Tighten to 23-33 Nm (16-24 lb-ft).
5. Install screws in overhead track retaining clips.
6. Install screw retaining A-pillar switch bracket to A-pillar.
7. Position drive belt guide at motor. Align drive belt and guides as required to ensure no binding prior to installing two screws.
8. Install shoulder belt bolt. Tighten to 11-16 Nm (8-12 lb-ft). Install plug button.
9. Connect electrical connectors.
10. Check system operation.
11. Install garnish mouldings.
12. Install front seat shoulder belt track to the track assembly as follows:
a. Return shoulder belt track carrier to B-pillar.
b. Pull the belt from the retractor on the console. Allow belt to lay flat across the seatback, with no twist.
c. Install shoulder belt to track assembly by locating anti-rotation pin in strap carrier and aligning it with notch in belt anchor.
d. Install Torx(R) head retaining bolt. Tighten to 11-16 Nm (8-12 lb-ft).
NOTE: When the shoulder belt is returned to the A-pillar, there should be a half-twist in the belt.
13. Check for proper operation of passive restraint system.
14. Install quarter trim panel and rear seat.
4-Door