Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Catalyst Shield: Service and Repair
Exhaust Inlet Pipe Shield
REMOVAL
1. Raise and support the vehicle.
2. Remove the exhaust inlet pipe shield clamp bolt and the exhaust inlet pipe shield clamp.
3. Remove the four exhaust inlet pipe shield bolts.
4. Remove the exhaust inlet pipe shields.
INSTALLATION
To install, reverse the removal procedure.
-
Tighten the exhaust inlet pipe shield bolts to 5-7 Nm (43-61 lb-in).
-
Tighten the exhaust inlet pipe shield clamp bolt to 5-7 Nm (43-61 lb-in).