Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Catalyst Shield: Service and Repair
Exhaust System Flex Tube Shield
REMOVAL
1. Remove the exhaust system flex tube shield clamp bolt and slide the exhaust system flex tube shield clamp out of the way.
2. Remove the two exhaust system flex tube shield bolts.
3. Remove the exhaust system flex tube shield.
INSTALLATION
To install, reverse the removal procedure.
-
Tighten the exhaust system flex tube shield clamp bolt to 5-7 Nm (43-61 lb-in).
-
Tighten the exhaust system flex tube shield bolt to 5-7 Nm (43-61 lb-in).