Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Power Steering Line/Hose: Service and Repair
Power Steering Reservoir to Pump
REMOVAL
1. Place a drain pan under the power steering pump.
2. Remove the two power steering reservoir pump hose bolts. Allow the power steering oil reservoir to drain into the drain pan.
3. Loosen the power steering reservoir pump hose clamp at the power steering oil reservoir. Remove the power steering reservoir pump hose from
the power steering oil reservoir.
4. Remove the power steering reservoir pump hose from the vehicle.
INSTALLATION
1. Position the power steering reservoir pump hose in the vehicle.
2. Install the power steering reservoir pump hose on the power steering oil reservoir.
3. Install the two power steering reservoir pump hose bolts. Tighten the two power steering reservoir pump hose bolts to 14-18 Nm (10-13 ft. lbs.).
4. Follow the start-up procedure. See: Power Steering Pump/Service and Repair/Power Steering Pump/Start Up Procedure After Power Steering
Pump or Gear Service
