Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
4. Remove the power steering return hose bracket bolt.
5. Disassemble the power steering return hose bracket and separate the power steering return hose and the power steering pressure hose.
6. Loosen the power steering return hose-to-intermediate line C clamp.
7. Remove the intermediate line C from the power steering return hose.
8. Remove the power steering return hose from the bottom of the vehicle.
INSTALLATION
1. To install, reverse the REMOVAL procedure.
^
Tighten the power steering return hose bracket bolt to 3-4 Nm (18-26 inch lbs.).
NOTE: Follow the start-up procedure. See: Power Steering Pump/Service and Repair/Power Steering Pump/Start Up Procedure After Power
Steering Pump or Gear Service
Steering Gear to Cooler Hose - Intermediate Hose A