Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Stabilizer Link: Service and Repair
Front
REMOVAL
1. Remove the front stabilizer bar.
2. Hold the front stabilizer bar link shaft with a wrench and remove the front stabilizer bar link-to-front suspension lower arm nut.
3. Remove the front stabilizer bar link, two lower suspension arm stabilizer bar insulators and washers from the front suspension lower arm.
INSTALLATION
1. To install, reverse the removal procedure.
^
Tighten the front stabilizer bar link-to-front suspension lower arm nut to 16-22 Nm (12-16 ft. lbs.).