Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
9. Remove the D-rings and oil seals from the forward clutch and coasting clutch pistons.
10. Check the components for deformation, fatigue, or damage. Replace if necessary.
NOTE: When replacing a spring retainer or return springs, replace them as a set.
11. Check the facing of the internal spline clutch plates for burns, cracks and damage.
12. Measure the thickness of the forward and the coasting clutch internal spline clutch plate facing. The standard thickness is 1.6 mm (0.063 inch) ,
with a wear limit of 1.4 mm (0.055 inch).
13. If an internal spline clutch plate facing is not within specifications, replace the internal spline clutch plates as a set.
14. Check the dish plates for deformation and damage.
15. Measure the thickness (t) of the dish plate.
16. The dish plate should measure 2.7 mm (0.106 inch). If the dish plate is out of specification, replace the dish plate.
17. Make sure that the check ball is not stuck in the front clutch cylinder.