Villager V6-181 3.0L SOHC VIN 1 EFI (1997)
Clutch: Service and Repair
Low Reverse Clutch
DISASSEMBLY
1. To remove the low/reverse clutch piston, apply compressed air to the oil hole of the low/reverse clutch while holding the low/reverse clutch piston.
2. Remove the low/reverse clutch cylinder seal and low/reverse clutch piston outer oil seal from the low/reverse clutch piston.
3. Check the components for deformation, fatigue or damage. Replace if necessary.
NOTE: When replacing a spring retainer or return springs, replace them as a set.
4. Check the facing of the low/reverse clutch internal spline clutch plates for burns, cracks, and damage.
5. Measure the thickness of the low/reverse clutch internal spline clutch plate facing. The standard thickness is 1.8 mm (0.071 inch) with a wear limit
of 1.6 mm (0.063 inch).
6. If a low/reverse clutch internal spline clutch plate facing is not within specifications, replace the internal spline clutch plates as a set.