Villager V6-201 3.3L SOHC VIN T SFI (1999)
Air Bag Control Module: Service and Repair
REMOVAL
1. Disconnect the battery ground cable.
WARNING: The backup power supply energy must be depleted before any air bag component service is performed. To deplete the
backup power supply energy, disconnect the battery ground cable and wait three minutes.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the
diagnostic procedure again.
2. Remove the four pushpins (two shown) and the CD changer cover (if equipped) or the console compartment door.
3. Remove the two screws and one plastic nut and position out the passenger side inner kick panel.