Villager V6-201 3.3L SOHC VIN T SFI (1999)
3. Clean the windshield glass.
^
Clean the inside edge of the windshield glass with an alcohol-free cleaner.
^
Wipe the edge of the windshield glass with a clean lint-free cloth.
4. Install the windshield glass moulding.
5. Apply Urethane Glass Prep meeting Ford specification WSB-M5B280-C directly inside the windshield glass edge and moulding on the blackout
ceramic coating.
^
Immediately wipe off the Urethane Glass Prep.
^
Repeat the application one time.
NOTE: Immediately wipe off the Urethane Glass Prep after application because it flash dries.
6. Apply Urethane Glass Primer meeting Ford specification WSB-M2G314-B around the entire outer edge of the inside of the windshield glass edge
and moulding.
^
Allow 10 minutes drying time.
CAUTION
^
If primer gets on your hands, remove it immediately.
^
Do not apply the Urethane Glass Primer inside of the blackout ceramic coating. The primer will permanently discolor the windshield glass.
7. Install Norton Foam Sealants 565 Black Foam tape meeting Ford specification ESB-M3G77-A to the pinch weld area.
^
Start at the bottom center of the pinch weld.