Pre-tensioners

Driver's airbag The driver's airbag is connected to the airbag control unit via the rotary coupler on Y and R wires.

Pre-tensioners

The right hand pretensioner is controlled by the DCU on N and NR wires.

The left hand pretensioner is controlled by the DCU on O and OU wires.

SRS warning lamp When the starter switch is operated to position II, the warning lamp (located on the instrument panel) receives battery voltage from fuse A4 on a W wire and a control signal from the airbag control unit on a P wire. The warning lamp will illuminate when the electrical circuits are initialised while the system performs a self-diagnosis test. If the system finds no fault during self diagnosis the warning lamp will extinguish after approximately 6 seconds.

In the event of a fault in the system the warning lamp will illuminate continuously or fail to illuminate during the self diagnosis test.