Model: MPi
- Make
- Mini
- Model
- Mini Workshop Manual
- Year
- 1996–2000
- Section
- Engine tuning data › Model: MPi
InformationModel: MPi
Model: MPi
Engine
| Type / Capacity | 12A2LK70/1275 cm3 |
| Firing order | 1 - 3 - 4 - 2 |
| Compression ratio | 10.0 : 1 |
| Idle speed, controlled by the ECM * | 900 æ 50 rev/min |
| Exhaust gas CO content at idle | less than 0.4% hot |
| Ignition timing at idle speed ¸c | 12°BTDC (nominal) |
| Valve rocker clearance (cold) | 0.27 to 0.33 mm |
Ignition Coil
| Type | Quad type dry |
| Part No | NEC 1000710 |
| Primary resistance at 20°C | 0.41 to 0.61 ohm |
| Secondary resistance at 20°C | 6200 to 6700 ohm |
| Consumption at engine idle speed | 4.7 to 6.7 amps |
Spark Plugs
| Type | NGK BPR6E |
| Plug gap | 0.80 to 0.90 mm |
Engine Management System
| Type | Two point injection |
| MEMS ECM | MNE 104290 |
| Fuel pump module | WFX 100810 |
| Injector/fuel pressure regulator | MKW 10016 |
| Fuel pressure | 3.0 æ 0.2 bar constant |
| Throttle position (TP) sensor | MJC 10020 |
| Intake air temperature (IAT) sensor | NNK 10001 |
| Crankshaft position (CKP) sensor | ADU 7340 |
| Camshaft position (CMP) sensor | NSC 100390 |
| Engine coolant temperature (ECT) sensor | MEK 100060 |
| Heated oxygen sensor (HO2S) | MHK 10004 |
| TP sensor voltage: | |
| Throttle closed | 0 to 1v |
| Throttle open 90° | 4 to 5v |
| Throttle open 65° | 3 to 4v |
| Fuel grade | 95 RON minimum - UNLEADED fuel |
CAUTION: Do not use LEADED fuel as it will damage the catalyst. Serious damage to the engine may occur if a lower octane number fuel than that recommended is used.
* No electrical load present
¸c Crankshaft degrees and rev/min
Parts & tools for this job For 1996 Mini Mini
- PARTEngine gasket setSearch: Mini Mini 1996 engine gasket set
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLFeeler gauge setSearch: feeler gauge set
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.