Cooper (R56) L4-1.6L (N12) (2008)
Important!
Journals of special tool 31 4 090 must be inserted completely into bores of front axle carrier!
Align special tools 31 4 051 and 31 4 090 to front axle carrier.
Support front axle carrier by operating workshop jack 00 2 030.
Release screws (1 to 3).
Installation:
Check threads for damage; if necessary, repair with Heli-Coil(R) thread inserts.
Make sure screws are installed in correct positions.
^
Screws (1) M 12x85
Tighten front axle carrier, middle, to body
M12 ........................................................................................................................................................................................................... 100 Nm
^
Replace screws (2) N10x60.
Tighten bracket, control arm rubber mount, to body
Replace screws M10
Jointing torque ............................................................................................................................................................................................. 59 Nm
Torque angle .................................................................................................................................................................................................... 90 °
^
Screws (3) M 12x62
Tighten rear end of front axle carrier to body
M12 ........................................................................................................................................................................................................... 100 Nm