Cooper (R56) L4-1.6L (N12) (2008)
Wiring Harness: Removal and Replacement
12 51 001 Replacing Wiring Harness Section For Engine
12 51 001 Replacing Wiring Harness Section For Engine (N12)
IMPORTANT: Read and comply with notes on protection against electrostatic damage (ESD protection).
Necessary preliminary tasks:
-
Read out fault memory of DME control unit
-
Switch off ignition
-
Disconnect battery negative lead
-
Remove intake filter housing
Unlock and remove cover (1).
Unlock the two rear plugs (1) and disconnect.
Unlock plugs (1) for camshaft sensors and disconnect.
Unlock plug (2) for oil pressure sensor and disconnect.