Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1325002.png)
Unlock and detach vacuum line (3).
Detach cable duct (4) upwards from holder.
Work step
Unlock plug for coolant temperature sensor and disconnect
Unlock plug on coolant thermostat and disconnect
Unlock plug for eccentric shaft sensor and disconnect
Unlock plugs for ignition coils and disconnect
Disconnect ground connection at cylinder head
NOTE:
Tightening torque
1AZGround connection for ignition coils
M5 .................................................................................................................................................................................................................... 5.5 Nm
Type: N12, N14
Unlock plug for front solenoid valve and disconnect
Unlock plug for control and monitor sensors and disconnect
Unlock plug for eccentric shaft positioning motor and disconnect
Unlock plugs for fuel injectors and disconnect
Unlock plug for differential pressure sensor and disconnect
Unlock plug for knock sensor and disconnect
Unlock plug for tank vent valve and disconnect
Unlock plug for crankshaft sensor and disconnect
Unlock plug for throttle valve assembly and disconnect
Unlock plug for rear solenoid valve and disconnect
Unlock plug for friction gear and disconnect
NOTE: Check stored fault messages.
Now clear the fault memory.
61 12 180 Replacing Wiring Harness on Function Carrier on Left or Right Front Door
61 12 180 Replacing Wiring Harness On Function Carrier On Left Or Right Front Door
Necessary preliminary tasks:
-
Remove front door trim panel
-
Remove armrest from front door trim panel
-
Remove cover on door handle
-
Remove switch for door mirror
-
Remove speaker trim from door trim panel
-
Remove speaker
Disconnect plug connection (1).
Unclip wiring harness holders (2).
Feed out wiring harness out of function carrier and remove.
Installation:
