Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1417001.png)
Wheels: Removal and Replacement
Removing or Installing Front or Rear Wheel
36 10 300 Removing or installing front or rear wheel
Special tools required:
^
36 1 250
^
36 2 020
Important!
Wheel was balanced electronically.
Follow instructions on initializing Run Flat Indicator (RPA).
Observe the following procedure to prevent shift errors and imbalance:
^
Loosen wheel bolts.
^
The wheel is positioned such that the valve is at the bottom.
^
If several wheels are removed simultaneously, mark with a piece of chalk on each tire the axle and side on which the corresponding wheel is fitted.
^
Mark alignment of wheel with respect to wheel hub.
^
Mark position of lockable wheel bolt.
^
Release wheel bolts and remove wheel.
Important!
Contact surfaces between:
^
brake disc and disc wheel
^
Brake disc and wheel hub must be clean and free from oil and grease.
Remove dirt, grease residues and corrosion from contact face (1) with a drill and special tool 36 1 250.
Important!
Do not operate special tool 36 1 250 with an impact screwdriver!
Note:
Degrease contact face with universal cleaner.
