Cooper (R56) L4-1.6L (N12) (2008)
/l4-1.6l_(n12)/Page-1030001.png)
Transmission Position Switch/Sensor: Service and Repair
24 10 006 Removing and installing/replacing gear position switch (AISIN)
Special tools required:
^
24 4 270
Important!
An incorrectly adjusted gearshift mechanism can result in gear teeth noises.
Necessary preliminary tasks:
^
Remove air intake filter housing
^
Remove intake filter housing boot.
Release cable lock nut (1).
Installation:
Adjust gearshift mechanism.
Note:
Illustration similar.
Disconnect plug (1) from gear position switch.
Unlock locking sleeve (3) in direction of arrow.
Remove cable upwards from holder.
Release nut (4) and remove selector lever.
Tighten selector lever to shaft
Selector lever to shaft
M8 ..................................................................................................................................................................................................................... 12 Nm
