Cooper Convertible (R57) L4-1.6L (N12) (2009)
Important!
Both camshafts have different identifications.
Mixing up the two camshafts will result in engine damage.
EX - Exhaust camshaft.
IN - Inlet camshaft
Insert camshaft (E) so that IN marking points upwards.
Position inlet camshaft (E) so that cams point upwards at an angle.
Attach special tool 11 9 551 to twin surface.
Make sure plain compression rings cable can move freely.
Installation:
Joint of plain compression rings must not point to a separating joint (risk of breakage!).