Cooper Convertible (R57) L4-1.6L (N12) (2009)
Front Subframe: Service and Repair
Lowering/Raising Front Axle Carrier (Universal Lifter)
31 11 506 - Lowering/raising front axle carrier (universal lifter)
Special tools required:
-
00 2 030
-
31 5 251
-
31 5 253
-
31 5 255
Necessary preliminary tasks:
-
Remove front wheels See: Wheels and Tires/Wheels/Service and Repair/Removal and Replacement/Removing or Installing Front or Rear Wheel.
-
If necessary, remove underbody protection.
-
Remove complete exhaust system.
-
Remove lower bumper trim.
-
Partially remove front left and right wheel arch covers See: Body and Frame/Fender/Front Fender/Front Fender Liner/Service and Repair.
-
R56: Partially remove underbody panelling on left and right.
-
If necessary, disconnect plug connection on ride-height sensor and expose line up to engine carrier
Important!
If the steering spindle is separated from the steering gear, this can result in damage to the steering-column switch cluster when the steering wheel is
turned!
Release screw (1).
Tightening torque 32 31 2AZ See: Steering/Steering Column/Specifications.
Detach lower section of steering spindle (2) from steering gear and swing towards rear.
Installation:
Clean thread to remove all remnants of screw securing adhesive.