Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-1292002.png)
-
00 9 322
IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and
must be observed without fail.
NOTE: The MINI badge is damaged when removed and must be replaced.
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on hood/bonnet and press down firmly.
* Liner is the protective film on a new badge.
Removing and Installing/Replacing Rear MINI Badge
51 14 012 Removing and Installing/Replacing Rear Mini Badge
Special tools required:
-
00 9 322
IMPORTANT: The Instructions on component cementing with double-sided adhesive tape serve as the basis for this repair instruction and
must be observed without fail.
