Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-1292003.png)
Removing badge:
Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322.
Fitting badge:
Pull liner* off adhesive tape (1), position badge over guide pins (2) on rear lid and press down firmly.
* Liner is the protective film on a new badge.
Removing and Installing/Replacing Rear Model Designation
51 14 110 Removing and Installing/Replacing Rear Model Designation
IMPORTANT: The Instructions for number/letter combination cementing serve as the basis for these repair instructions and must be followed
without fail.
Fitting dimensions (R50/R52/R53/R56):
