Cooper S (R56) L4-1.6L Turbo (N14) (2009)
/l4-1.6l_turbo_(n14)/Page-871004.png)
Disengage brake hose from holder (1).
Detach brake hose (2) from brake caliper.
Installation:
Tighten brake hose to brake caliper, rear
3AZ Brake hose to brake caliper, rear
M10 .............................................................................................................................................................................................................. 24 ± 2Nm
Important:
Never twist brake hose when installing it and avoid all contact with parts attached rigidly to the body.
Note:
First tighten brake hose on brake caliper.
Insert brake hose in bracket and screw onto brake pipe.
Pull brake lining wear sensor out of brake lining (right side only).
Unscrew guide bolts (1).
If necessary, grip at hexagon head (2).
Remove brake caliper.
Installation:
Replace guide screws.
Tighten guide screws (hexagon screw)
3AZ Guide screws (hexagon screw)
13 mm Wrench size ...................................................................................................................................................................................... 35 ± 3Nm
Note:
