3000GT V6-3.0L SOHC (1998)
4. With the brake assembly removed, use a spring scale to measure the rotary sliding resistance of the hub in the forward direction.
5. Clean the piston and then using the special tool, push the piston into the cylinder (caliper).
6. Apply repair kit grease to both sides of the inner shims.
Specified grease: Brake grease SAE J310, NLGI No. 1
CAUTION:
1. Make sure that the friction surfaces of pads and brake discs are free of grease and other contaminants.
2. The grease should never squeeze out from around the shim.
7. Start the engine, depress the brake pedal firmly two to three times and stop the engine.
8. Give the brake disc ten turns in the forward direction.
9. Using a spring scale, measure the rotary sliding resistance of the hub in the forward direction.
10. Obtain the drag force of the disc brake (the difference between the values measured in 9 and 4).
Standard value: 70 N (15.4 lbs.) or less
11. If the drag force of the brake exceeds the standard value, disassemble the piston and check for dirty or corroded piston sliding surface and
deteriorated piston seal.
