3000GT V6-3.0L SOHC (1998)
Brake Rotor/Disc: Testing and Inspection
Rear Disc
REAR BRAKE DISC THICKNESS CHECK
1. Remove dirt and rust from brake disc surface.
2. Measure disc thickness at 4 locations or more.
Standard value:
<FWD> 18.0 mm (0.71 inch)
<AWD> 20.0 mm (0.79 inch)
Limit:
<FWD> 16.4 mm (0.65 inch)
<AWD> 18.4 mm (0.72 inch)
Replace the discs and pad assembly for both sides left and right of the vehicle if they are worn beyond the specified limit.
REAR BRAKE DISC RUN-OUT CHECK
1. Remove the rear brake assembly, and support it by a wire, etc.
Place a dial gauge approximately 5 mm (0.2 inch) from the outer circumference of the brake disc, and measure the run-out of the disc.
Limit: 0.08 mm (0.0031 inch) or less
NOTE: Tighten nuts to secure the disc to the hub.