3000GT V6-3.0L SOHC (1998)
INSPECTION
Using Scan Tool
HARNESS INSPECTION
Measure the ignition switch (IG) terminal input voltage.
-
Engine control module connector: Disconnected Voltage (V): 0-1 (Ignition switch: OFF)
Battery positive voltage (Ignition switch: ON)
OK: GO TO STEP 2
NG: Repair the harness. (Ignition switch - 99) or check the ignition switch
Measure the power supply voltage of the MFI relay.
-
MFI relay connector: Disconnected
Voltage (V): Battery positive voltage (Ignition switch: OFF)
OK: GO TO STEP 3
NG: Repair the harness. (Battery - A3, A4)
Check for an open-circuit, or a short-circuit to ground, between
the engine control module and the MFI relay.
-
Engine control module connector: Disconnected
-
MFI relay connector: Disconnected
OK: GO TO STEP 4
NG: Repair the harness. (A2-57)
Check for an open-circuit, or a short-circuit to ground between the engine control module and the MFI relay.
-
MFI relay connector: Disconnected