3000GT V6-3.0L SOHC (1998)
Reassembly Service Points
>A< Wheel Bearing Installation
1. Fill the wheel bearing with multipurpose grease.
2. Apply a thin coating of multipurpose grease to the knuckle and bearing contact surfaces.
3. With the wheel bearing inner race removed, press-in the bearing by using the special tools.
4. Install the wheel bearing inner race to the wheel bearing.
>B< Oil Seal (Hub Side) Installation
1. Drive the oil seal (hub side) into the knuckle by using the special tools until it is flush with the knuckle end surface.
2. Apply multipurpose grease to the lip of the oil seal and to the surfaces of the oil seal which contact the hub.
>C< Wheel Bearing Starting Torque Adjustment
1. Use the special tool to mount the hub assembly onto the knuckle.
2. Tighten the nut of the special tool to 200-260 Nm (145-188 ft. lbs.).
3. Rotate the hub assembly in order to seat the bearing.
4. Measure the wheel bearing starting torque (hub starting torque) by using the special tools.
