3000GT AWD V6-2972cc 3.0L DOHC Turbo 24 Valve (1996)
3. Incline the G sensor toward the vehicle rear gradually and check that continuity is lost at an angle of 300 or more.
<From 1996 models>
1. Disconnect G-sensor connector and connect special tool between terminals of the disconnected connector.
2. With the ignition switch turned ON, read output voltage between terminals No.2 and No.3.
Standard value: 2.3 - 2.7 Volts
3. With the special tool connected, fix the connector in such a manner as to direct the front mark on the G-sensor mounting surface downward
and read output voltage between terminals No.2 and No.3.
Standard value: 3.3 - 3.7 Volts
4. If the output deviates from the standard value, make sure that nothing is wrong with the power supply wire and ground wire and then
replace G-sensor.