3000GT Convertible AWD V6-2972cc 3.0L DOHC Turbo (1995)
Cruise Control Servo: Testing and Inspection
Electrical Type
Continuity Inspection
1. Disconnect electrical connector.
Fig. 31 Actuator Inspection
2. Measure clutch coil resistance between terminals 1 and 2, Fig. 31. Standard value is 20 ohms.
Actuator Operation Inspection
Fig. 32 Actuator Circuit Inspection
1. Connect terminal 1 of actuator through ammeter to battery positive terminal, Fig. 32.
2. Connect terminal 2 to battery negative terminal.
3. Solenoid should emit an audible click and ammeter should measure 0.5-0.7 amps. If not, proceed as follows:
a. If no solenoid noise is heard and ammeter reads 0 amps, check for damaged or disconnected clutch coil wiring.
b. If no solenoid sound is heard, but ammeter reads infinite, check for clutch coil short circuit.
Motor Pull Direction & Limit Switch Operation Inspection
Fig. 37 Motor Pull Direction & Limit Switch Operation