3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
Acceleration/Deceleration Sensor: Service and Repair
REMOVAL
Pre-removal Operation:
-
Front and Rear Console Assemblies Removal.
CAUTION: Supplemental Restraint System (SRS) When installing or removing the instrument panel, don't allow any impact or shock to the
SRS-Electronic Control Unit (ECU).
Follow removal steps outlined in illustration.
INSPECTION
G Sensor Check
1) Disconnect G-sensor connector and connect special tool, MB991348, between terminals of the disconnected connector.
2) With the ignition switch turned ON, read output voltage between terminals No. 2 and No. 3.
Standard value: 2.3 - 2.7 V
3) With special tool MB991348 connected, rotate the sensor in such a manner as to direct the front mark on the G-sensor mounting surface
downward and read output voltage between terminals No. 2 and No. 3.
Standard value: 3.3 - 3.7 V
