3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
<A> Pad Pin Removal.
Holding the cross spring with hand, remove the pad pin.
Removal Of Pads And Shims
<B> Pad Assembly Removal.
Using a screwdriver, remove the pad assembly.
<C> Pistons Removal.
Install a wood block as shown and send compressed air through the port, to which brake hose is attached, to remove the pistons.
At this time, make sure that the four pistons come out evenly.
CAUTION:
1. Be careful not to get your fingers to be pinched.
2. Be careful not to let the brake fluid splash.
<D> Piston Seal Removal.
1) Remove the piston seal.
CAUTION: Do not damage the cylinder inner surface.
2) Clean the piston surfaces and cylinder inner surfaces with trichloroethylene, alcohol, or the specified brake fluid.
Specified brake fluid: Conforming to DOT3 or DOT4