3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
INSPECTION
-
Check cylinder for wear, damage or rust.
-
Check piston surface for wear, damage or rust.
-
Check caliper body or sleeve for wear.
-
Check pad for damage or adhesion of grease and check backing metal for damage.
Pad Wear Check
Measure the thickness at the thinnest and worn area of the pad. Replace pad assembly when pad thickness is less than the limit value.
Standard value: 10.0 mm (0.39 inch)
Limit: 2.0 mm (0.08 inch)
CAUTION:
1. When the limit is exceeded, the brake pads on both the left and right wheels must be replaced as a set.
2. If there is a large difference in thickness between the pads on the right and left wheels, check the sliding portions of the caliper.
LUBRICATION POINTS