3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
6) Slide the special tool slowly toward the center until the projection of the shaft comes into contact with the brake booster push rod end as shown
in the illustration A.
If the result is as shown in the illustration B and C, adjust the push rod length as follows so that the contact given in the illustration A may be
obtained.
B: Make the push rod retract if it touches the shaft at a point other than the projection.
C: Make the push rod extend if it does not contact any part of the shaft.
Post-installation Operation:
-
Brake Fluid Supplying.
-
Bleeding.
-
Brake Pedal Adjustment.
