3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
damaged, accurate wheel speed detection may not be expected.
2) Measure resistance between speed sensor terminals.
Standard value: 1.44 - 1.76 k ohms
If the internal resistance of the speed sensor is out of specification, replace with a new one.
3) Check the speed sensor cable for open circuit and replace if faulty.
NOTE: Remove the cable clamp from the body and, while flexing the cable near the clamp, check for temporary open circuit. Also check
connector connection and terminal insertion.
Toothed ABS Rotor Check
Check whether the ABS rotor teeth are broken or deformed. Replace the ABS rotor if the teeth are damaged or deformed.
INSTALLATION
Installation in reverse order as removal.
Installation Service Point.
>A< Rear Speed Sensor Installation.
The rear speed sensor pole piece-to-ABS rotor tooth surface clearance is not adjustable. In this case, measure the sensor mounting surface-to-ABS
rotor tooth surface clearance.
Standard value (A): 28.15 - 28.45 mm (1.11 - 1.12 inch).
Post-installation Operation:
-
Splash Shield Removal.