3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
Fig. 15 Installing Rear Exhaust Manifold Nuts (Turbo)
>A< Exhaust Manifold Installation. (REAR)
Tighten the nuts in the following order.
(1) Tighten five nuts (A) to 30 Nm (22 ft. lbs.).
(2) Tighten nuts (B) to 47 - 53 Nm (34 - 38 ft. lbs.).
(3) Back off nuts (B) until torque value of 10 Nm (7 ft. lbs.) is achieved.
(4) Tighten nuts (B) to 29 - 31 Nm (21 - 22 ft. lbs.).
NOTE:
1. Fit the cone disc spring with the grooved side facing the nut.
2. Install the nut, cone disc spring and washer in the order shown in the illustration.
>B< Exhaust Manifold Stay Installation.
With the exhaust manifold stay resting on the exhaust manifold, fit it along with the exhaust manifold over the studs.
Fig. 16 Installing Front Exhaust Manifold Nuts (Turbo)
