3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
-
Engine control module connector: Disconnected
OK: GO TO STEP 4
NG: Repair the harness. (A B C2 - 1 24 10)
Check for an open-circuit, or a short-circuit between the rear bank injector and the engine control module.
-
Connector: Disconnected
-
Engine control module connector: Disconnected
OK: STOP
NG: Repair the harness. (D2 5 6-9 2 25)
INJECTOR CHECK
Measurement of Resistance between Front Bank Terminals
(1) Remove the injector connector.
(2) Measure the resistance between terminals.
Standard value: 2 - 3 Ohms [at 20°C (68°F)]
(3) Install the injector connector.
Measurement of Resistance between Rear Bank Terminals
(1) Disconnect the injector connector.
(2) Measure the resistance between terminals.
Standard value: 2-3 Ohms [at 20°C (68°F)
(3) Reconnect the injector connector.
RESISTOR CHECK
Measurement of Resistance between Terminals