3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
4. Remove rear console assembly.
5. Remove SRS-ECU and harness connector connection.
6. Remove SRS-ECU.
Installation
To install reverse the removal steps and note the following.
6. SRS-ECU Installation
CAUTION: The SRS may not activate properly if SRS-ECU is not installed properly, which could result in serious injury or death to the
vehicle's driver or front passenger.
Post-installation Inspection
Reconnect the negative battery terminal. Turn the ignition switch to "ON". Does the "SRS" warning light illuminate for about 7 seconds, turn OFF and
then remain OFF for at least 5 seconds? If yes, SRS system is functioning properly. If no, refer to SRS Warning Light. See: SRS Warning
Light/Testing and Inspection