3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
2. Secure the threaded portion of the end plug at two places by using a punch.
>M< Total Pinion Torque Adjustment (-)
1. Position rack at its center. With special tool, tighten rack support cover to 15 Nm (11 ft. lbs.).
2. In neutral position, rotate pinion shaft clockwise one turn/4-6 seconds with special tool. Return rack support cover 30° - 60° and adjust torque
to the standard value.
Standard value: 0.6 - 1.3 Nm (5 - 11 inch lbs.)
CAUTION:
-
When adjusting, set the standard value at its highest value.
-
Assure no ratcheting or catching when operating rack towards the shaft direction.
NOTE: When it cannot be adjusted within the specified return angle, check rack support cover components or replace.
3. After adjusting, lock rack support cover with lock nut.
>N< Tie Rod Installation (7)
After installing tie rod to rack, fold tab washer end (2 locations) to tie rod notch.
>O< Tie Rod End Installation (2)
Screw in tie rod end to have its right and left length as illustrated. Lock with lock nut.