3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
Limit: 1.8 Nm (16 inch lbs.) or less
NOTE: The starting torque must be within the limit and, in addition, the bearing must not feel rough when rotated.
5. Measure to determine whether the end play of the hub is within the specified limit or not.
Limit: 0.05 mm (0.002 inch)
6. If the starting torque and hub end play are not within the limit range while the nut is tightened to 200-260 Nm (145-188 ft. lbs.), the bearing,
hub and/or knuckle have probably not been installed correctly. Repeat the disassembly and assembly procedure.
>D< Oil Seal (Drive Shaft Side) Installation
Drive the oil seal (drive shaft side) into the knuckle until it contacts the snap ring. Apply multipurpose grease to the lip of the oil seal.
INSPECTION
-
Check the hub and brake disc mounting surfaces for galling and contamination.
-
Check the knuckle inner surface for galling and cracks.
-
Check for defective bearing.
