3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
1. Remove the Lobro joint boot from the Lobro joint assembly.
2. Put mating marks on the outer race, cage and inner race with a scriber before removing the outer race and balls.
CAUTION: Note the positions of balls so that they can be reinstalled in their original positions.
3. Remove the inner race with cage from the center propeller shaft by using a puller (commercially available).
NOTE: When changing the grease on the Lobro joint assembly, wipe off the grease and clean the outer and inner races, cage and balls.
4. If the outer race cannot be removed, remove the complete Lobro joint assembly from the center propeller shaft by using a puller (commercially
available).
<F> Lobro Joint Boot Removal