3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
11. Adjust the width of opening in the special tool (W) to standard value in the same manner as described in (4).
Standard value (W): 3.2 mm (0.126 inch)
12. Install the boot band (large) against the projection at the boot end to provide clearance D as shown in the illustration.
13. Crimp the boot band (large) with the special tool in the same manner as described in 6 above.
14. Make sure that the amount of boot band crimping is within the range of standard value (E).
Standard value (E): 2.4-2.8 mm (0.094-0.110 inch)
<When amount of crimping is above 2.8 mm (0.110 inch)>
Readjust W given in 11 to a value obtained by the following formula and repeat work described in 13 above.
W = 5.8 mm (0.228 inch)-E
[Example: When E = 2.9 mm (0.114 inch), W = 2.9 mm (0.114 inch)]
<When amount of crimping is below 2.4 mm (0.094 inch)>
Remove the boot band, readjust W given in 11 to a value calculated by the following formula and repeat work described in 12 and
13 by using a new boot band.
W = 5.8 mm (0.228 inch)-E
[Example: When E = 2.3 mm (0.091 inch), W = 3.5 mm (0.138 inch)]
15. Make sure that the boot band does not protrude from its mounting area. If the band protrudes, replace it with a new band and repeat work
described in 12 through 14.