3000GT VR-4 AWD V6-2972cc 3.0L DOHC MFI Twin Turbo (1998)
Wheel Bearing: Testing and Inspection
Rotary Sliding Resistance Check
REAR WHEEL BEARING ROTARY-SLIDING RESISTANCE CHECK
1. Remove the drive shaft from the companion flange.
2. Remove the brake pad or caliper assembly.
3. Attach a spring scale to the hub bolt, then, pulling the balance at a right angle to the hub bolt, measure the rotary-sliding resistance to see whether
it is within the limit value.
Limit: 12 Nm (2.6 lbs.)
4. If the rotary-sliding resistance exceeds the limit value, check the tightening torque of the axle shaft companion flange. If it is normal, replace the
bearing.
