Cordia L4-2.0L SOHC (1984)
NOTE If the oxygen sensor voltage is out of specification, drive the car until it is warm enough to activate the oxygen sensor and then without shutting
off the engine, measure the voltage output of the oxygen sensor at the computer.
7.
Correct connections and replace sensors as required, and then disconnect the battery for 30 seconds to erase the computer's memory of the
malfunction. Re-check the appropriate terminal to verify that the malfunction has been corrected.
NOTE:
To prevent damage to the computer, be sure the ignition switch is OFF before disconnecting the battery cable.
It is not necessary to perform the tests in any prescribed sequence. We recommend beginning with the "ignition OFF-ON" series and ending with the
"IDLE" series. For convenience, begin with connector "A" and then go to connector "B"
1983 Starion Eci Voltmeter Check
