Cordia L4-2.0L SOHC (1984)
Throttle Valve Cable/Linkage: Adjustments
Throttle Control Cable, Adjust
1.
Place carburetor throttle lever in the curb idle position.
Fig. 2 Throttle cable adjustment
2.
Raise throttle cable cover B upward, then loosen cable lower mounting bracket bolt, Fig. 2.
3.
Move cable lower mounting bracket until clearance between nipple and top of cable cover A is .02-.06 inch, then tighten cable lower mounting
bracket bolt to 9-10.5 ft. lbs.
4.
With throttle lever in the wide open position, pull throttle cable upward to ensure that cable has freedom of movement.
Kickdown Band, Adjust
1.
Remove snap ring from kickdown servo cover, then the cover.
Fig. 3 Kickdown band adjustment
*** UPDATED BY TSB-85-21-009 AUGUST, 1990
2.
Loosen locknut, then, while holding kickdown servo piston from turning, torque adjusting screw to 7 ft. lbs. and then back off adjusting screw
2-2.5 turns and re-tighten to 3.5 ft. lbs. Fig. 3.
3.
Prevent adjusting screw from turning and torque locknut to 18-23 ft. lbs.
4.
Install new seal ring in groove in outside surface of cover.
5.
Install cover and snap ring.