Diamante V6-2972cc 3.0L SOHC (1992)
Crankshaft Main Bearing Seal: Service and Repair
Front Seal
Fig. 30 Removing Oil Seal
1.
Disconnect battery ground cable.
2.
Release fuel system pressure.
3.
Remove transaxle as outlined in TRANSMISSION CLUTCHES DIFFERENTIALS AXLES AND DRIVE SHAFTS/AUTOMATIC
TRANSAXLE/COMPONENT REPLACEMENT AND REPAIR PROCEDURES/TRANSAXLE.
4.
Secure crankshaft using end yoke holder tool No. MD998719 on SOHC engines or No. MD998754 on DOHC engines.
5.
Remove adapter and driveplates.
6.
Cut out a portion in camshaft oil seal lip, Fig. 30.
7.
Cover tip of a suitable screwdriver with a clean soft cloth and pry out seal at cut out portion of seal. Use care not to damage camshaft or
cylinder head.
8.
Reverse procedure to install, using seal installer tool No. MD998718-01 or equivalent to install rear main oil seal.
