Diamante V6-2972cc 3.0L SOHC (1992)
8. INSTALLATION OF CLUTCH COIL
(1) Align the pin of the clutch coil with the pin hole in the front housing, and then fit it into the hole.
(2) Install the snap ring so that the tapered surface is at the outer side.
4. INSTALLATION OF ARMATURE PLATE
Align the mating mark of the crankshaft spline and the mating mark of the armature plate, and then fit them together.
3. INSTALLATION OF NUT
AIR GAP ADJUSTMENT
Check whether or not the air gap of the clutch is within the standard value.
Standard value: 0.4-0.65 mm (.02- .03 in.)
NOTE: If there is a deviation of the air gap from the standard value. make the necessary adjustment by adjusting the number of shims.