Diamante V6-2972cc 3.0L SOHC (1992)
2.
Using an external 12V battery, connect a jumper wire to ground the external battery negative terminal to the compressor. Then connect another
jumper wire to the external battery's positive terminal. Momentarily touch the jumper wire to terminal # 1 on the compressor side of the connector.
The magnetic clutch can be considered OK if a "click" comes from the clutch. If there is no "click" check the magnetic clutch using procedures
shown in the service manual.
3.
Connect the positive jumper wire to the compressor side terminal # 1. While watching the compressor clutch for movement, turn the engine over
by hand using a 1/2" drive socket extension and ratchet on the crankshaft bolt.
CAUTION:
Do not use the starter to crank the engine. If the compressor is locked-up, cranking the engine can break the belt.
If the compressor pulley does not rotate, replace the compressor. Refer to the service manual for compressor replacement instructions.