Diamante V6-2972cc 3.0L SOHC (1992)
Throttle Position Sensor: Testing and Inspection
Throttle Position Sensor
Engine Control Module Connector--For Pin Applications See Components
To test the Throttle Position Sensor, located on the throttle body, proceed as follows.
COMPONENT TEST
1.
Disconnect the throttle position sensor connector.
2.
Measure the resistance between terminals 1 and 4 of the throttle position sensor connector.
Terminal 1: Sensor power
Terminal 4: Sensor ground
Standard Value
3.5 - 6.5 K ohm
3.
Connect an analog type ohmmeter between terminals 1 and 2.
Terminal 1: Sensor ground
Terminal 2: Sensor output